dispatcher support

A Driver Detention Clock That Stays Accurate Across a Handoff

A practical handoff routine for keeping detention time accurate when a load changes dispatchers, shifts, or facilities.

Trucking VA Team · · 4 min read

A Driver Detention Clock That Stays Accurate Across a Handoff trucking guide thumbnail
Table of contents9 sections

Detention time is simple in principle: the clock starts when the driver arrives and ends when the loading or unloading is complete. In practice, the clock changes hands several times. A dispatcher goes off shift, a facility changes its check-in process, or a driver sends an update from a phone that loses signal. The minutes that matter are often the ones nobody recorded.

A detention clock that survives a handoff is a shared record, not a single dispatcher's note. It captures the arrival, the check-in, the start, the delay reason, and the release in a form the next person can continue. That record protects the driver's pay and the carrier's claim.

Record the arrival and the check-in separately

The driver's arrival at the facility and the facility's check-in are two different events. Record the arrival time, the gate or entrance, and the check-in time. A long gap between them is part of the delay and should be visible.

If the driver cannot check in because the office is closed or the system is down, record that fact and the time. The delay may be the facility's, but the evidence has to show it. A photo of the closed window or a timestamped message is useful.

Start the clock from a defined event

Decide whether detention starts at arrival, at check-in, or at the appointment time. Write the rule down and use it consistently. Different customers and brokers may define it differently, so the load record should state which rule applies.

When the rule changes, note the change on the load. A dispatcher who assumes the wrong start time can undercount by an hour. The note prevents that mistake at the handoff.

Capture the reason for the delay

A detention claim needs a reason: dock congestion, paperwork, equipment failure, a late receiver, or a facility policy. Record the reason in the driver's words and, where possible, the name of the person at the facility who gave it.

Do not editorialize. "Waiting for a dock" is a fact; "the receiver is disorganized" is a judgment. The claim is stronger with the fact and the time. The judgment can be added in a separate internal note if needed.

Keep the clock visible at handoff

When a shift changes, the outgoing dispatcher should hand off the open detention items with the arrival time, the current status, and the expected release. The incoming dispatcher should acknowledge the items and continue the clock without restarting it.

A handoff note that says "detention pending" is not enough. The next person needs the times, the contact, and the next action. A short structured note is faster than a phone call and easier to review.

Update the driver

A driver waiting at a dock needs to know that the delay is being tracked. Send a brief update with the expected next check. A driver who believes nobody is watching may leave, and a departure changes the claim.

If the driver is running out of hours, escalate. The detention clock and the hours clock are different, but both affect the decision. The dispatcher should not trade safety for a claim.

Close with a release time and evidence

Record the release time, the person who released the driver, and any document such as a signed bill of lading or a gate pass. The release time ends the clock; the evidence supports the claim.

If the facility refuses to sign, record the refusal and the time. A photo of the loaded or unloaded trailer and a timestamped message can support the record. Do not alter a document to add a time later.

Reconcile the clock before invoicing

Before the accessorial is invoiced, reconcile the detention record with the load, the appointment, and the driver's pay. A mismatch between the claim and the driver's settlement is a serious error.

The reconciliation should be a short checklist: arrival, start rule, delay reason, release, evidence, and approval. A second person should review high-value claims. The review protects the carrier and the driver.

Review detention patterns monthly

Look at detention by facility, customer, and time of day. A facility with repeated long waits may need a scheduling change or a conversation. A customer whose definition of detention differs from the carrier's may need a contract clarification.

Do not use the review to pressure drivers to leave before release. The pattern is about the facility and the process, not the driver's patience.

Key takeaways

  • Record arrival and check-in separately, and state which event starts the clock.
  • Capture the delay reason in the driver's words with the time and the facility contact.
  • Hand off open detention items with times, status, and next action, and acknowledge them.
  • Close with a release time and evidence, reconcile before invoicing, and review patterns monthly.

Detention is a small clock with a large effect on driver pay and customer relationships. A shared record that survives the handoff keeps the minutes honest and the claim defensible.

For related workflows, see the weather reroute exception queue and the trucking VA services overview.